Inductive Loops

Inductive loops can be very tricky to make and install. Our Saw-Cut and Direct Burial Loops are designed for easy installation. They are pre-formed with recommended loop sizes for commercial or domestic applications. Direct Burial loops are ideal for new driveways on which concrete is yet to be poured while Saw-Cut loops are ideal for existing driveways.

Repeat service calls on new loops installations are mostly due to detector lock-ups and false detections. Air pockets form when there isn’t enough space for sealant to fully encapsulate the wire. Because the wires are not encapsulated they are able to move slightly in the groove, this can cause false detections and detector lock up. Elsema’s inductive loops are pre-formed and when installed according to the instructions, these problems can be avoided. See our loop selection table.

Elsema also stocks Saw-Cut loop sealants.

Saw-Cut Loops with 30 metres of lead-in wire

Saw cut Inductive loops
SCL7 7.2 metre Saw-Cut Loop
SCL9 9 metre Saw-Cut Loop
SCL10 9.6 metre Saw-Cut Loop
SCL12 12 metre Saw-Cut Loop

Direct Burial Loops with 30 metres of lead-in wire

Direct Buried Inductive loops
DBL7 7.2 metre Direct Burial Loop
DBL9 9 metre Direct Burial Loop
DBL10 9.6 metre Direct Burial Loop
DBL12 12 metre Direct Burial Loop

Loop Selection Table

pre made loop

Can’t decide on the loop size? Have a look at our loop selection table. We have done the research on loop sizes and driveway width.

Loop Goop (Sealent)

pre made loop

Loop Goop (Sealant) is a tough and durable polyurethane resin designed to encapsulate, protect and insulate inductive loops for garage doors, gates, and parking applications.

Download Catalogue

  • Automatic sliding gate motor kits
  • Automatic swing gate motor kits
  • Solar gate kits
  • Control cards
  • Door controls
  • Keyring Remotes
  • IP66 rated Cases
  • Solar Panels
  • Backup Batteries
  • Transmitters
  • Receivers
  • Antennas
Elsema Catalogue
Download Catalogue