|
FMR-232R
Computer Receiver with 2 Relay Outputs & Database Software
Features
• Used in conjunction with computer database software
• 2-channel Receiver with supply, antenna, RS232C & relay connections
• Up to 500 different transmitters can be entered into the database
Applications
• For monitor of transmission of remote control transmitters using computer database software |
 Click image to enlarge
 Download Datasheet
 Download Demo Software
|
Description
The FMR-232R is a two-channel receiver with supply, antenna, RS232C and relay connections. The receiver is enclosed in Elsema's black UBB plastic case.
The FMR-232R receiver is used to monitor the transmission of remote control transmitters using computer database software.
The software runs on an IBM computer and has a database to which it records the transmitter identity every time the transmitter is used. Each transmitter can have up to five different identifiers. For example, the name, phones, fax and address of a person using the transmitter.
Up to five hundred different transmitters can be entered into the database.
The software can be configured to prompt the computer user an alarm dialog box when a transmitter is transmitted. It can even operate two different relay outputs. Each relay has a software momentary mode.
A demo version of the software can be downloaded from here. If the hardware receiver and transmitter are to be used, the registered software must be purchased.
All FMT-… series transmitter can be used with this registered software.
Elsema’s ANT27MHz series antennas will give a reliable control range of up to 200 metres, when used with Elsema’s FMT-301, FMT-302 and FMT-304 transmitters.
Compatibility
All Elsema type FMT-… series
KEY-301, KEY-302, KEY-304
FMT-301, FMT-302, FMT-304
FMT-401, FMT-402, FMT-404
FMT-312E, FMT-31202E, FMT-31204E
Products in the Range
|
|
|
|
|
FMR-201
Single Channel Receiver with Open CollectorOutput |
FMR-203
2-Channel PCB Strip Receiver |
FMR-212
Single Channel Receiver with Relay Output |
FMR-212T
Single Channel Receiver with Timer Controlled Relay Output |
FMR-24001
Single Channel 240V Receiver with Relay Output |
|
|
|
|
|
FMR-24002
2-Channel 240VAC Receiver with 2 Relay Outputs |
FMR-202
2-Channel Receiver with 2 Relay Outputs |
FMR204-12
4-Channel 12V Receiver with 4 Relay Outputs |
FMR204-24
4-Channel 24V Receiver with 4 Relay Outputs |
FMR-204/16
4/16 Channel Receiver with Open Collector Outputs |
|
|
|
|
|
FMR-232R
Computer Receiver with 2 Relay Outputs & Database Software |
FMR-100
Receiver for Multi-Channel System
|
RXD-101
Decoder for Multi-Channel System |
|
|
Technical Data
| Case |
Black UBB Plastic |
| Supply Voltage |
10 - 14 Volts AC or DC |
| Current Consumption |
18mA (Standby)
76mA (Both Relays On) |
| Receiver Type |
Dual Conversion Superheterodyne |
| Receiving Frequency |
27.145MHz (Other frequencies available: 27.045, 27.195 & 27.455MHz. NB. 27.455MHz is available for Europe Only) |
| Type of Crystal Used |
10.245MHz, Fundamental, 20pF, 30ppm
16.495MHz, Fundamental, 20pF, 30ppm |
| Operating Temperature Range |
-5 to 50°C |
| 1st IF Freq |
10.7MHz |
| 2nd IF Freq |
455kHz |
| Selectivity |
-6dB at ±5kHz, -20dB at ±6kHz |
| Image Rejection |
At 26.285MHz better than -60dB |
| Sensitivity |
-107dBm or 1uV |
| Type of demodulation |
Narrow-bandwidth Frequency Modulation (FM) |
| Occupied Band Width |
±5.0kHz |
| Baud Rate |
4800bps |
| Data |
No parity, 8 bits, 1 stop bit |
| Connections |
Antenna: SO-239 50 ohms socket
Supply: 6-way screw type terminal block
Data Out: 9-pin female D-type
2 Relay Output Contacts: Common (C) & Normally Open (NO) |
| Serial Cable |
9-pin Male to 9-pin Female |
| Antenna |
Elsema’s ANT27MHz series antennas or piece of approximately 300 mm long wire for short range applications. |
| Dimensions |
125 x 80 x 33mm |
| Weight |
194g |
| Compatible Transmitters |
All Elsema type FMT-... 27MHz series and KEY-3.. series |
Application Diagram
|
